| Step | | Procedure & Parts & Tools |
| 1 |
|
LOCATE CHARGER PLUG ON THE BACK OF MACHINE AND PULL TO DISCONNECT IT.
|
| 2 |
|
REMOVE THE 6 SCREWS FROM THE HANDLE.
| Screwdriver-phillips |
|
|
| 3 |
|
PULL THE COVER/CONTROL PANEL FROM THE MACHINE.
|
| 4 |
|
LOCATE BRUSH MOTOR PLUG ON THE CONTROL BOARD. PULL TO UNPLUG IT. CUT OFF BAD SECTION OF WIRING, IF WIRE IS STILL LONG ENOUGH TO REACH THE CONTROL BOARD, STRIP WIRE ENDS A 1/4 IN AND REINSTALL WIRES INTO PLUG. SLIDE WIRES IN PLUG AND CLICK IN PLACE. IF WIRING IS TOO SHORT, SPLICE IN AN ADDITIONAL LENGTH, USE AN APPROVED CONNECTOR SUCH AS A WIRE NUT AND TAPE, THEN CONNECT TO CONTROL BOARD. REVERSE STEPS 1 AND 2 TO REASSEMBLE MACHINE. RECONNECT CHARGER PLUG.
|
|